Tag Archives | Shaper

Shaper: Working and Lubrication | Machine Tools | Industrial Engineering

In this article we will discuss about:- 1. Introduction to Shaper 2. Shaper Size 3. Classification 4. Working 5. Hydraulic Shaper 6. Lubricating 7. Table Cross-Feed Mechanism 8. Quick Return Mechanism of Ram 9. Some Important Do's and Do not's. Introduction to Shaper: The shaper makes use of a single point tool that traverses the work and feeds over at [...]

By |2017-07-24T11:54:25+05:30July 24, 2017|Shaper|Comments Off on Shaper: Working and Lubrication | Machine Tools | Industrial Engineering

Principal Parts of Shaper | Machine Tools | Industries | Engineering

The following points highlight the principal parts of a shaper used in the industries. The parts are: 1. Power Transmission 2. Ram 3. Shaper Head (Tool Head Assembly) 4. Shaper Gibs 5. Clearance Angles 6. Rake Angle. Part # 1. Power Transmission: The power is transmitted to the shaper from an electric motor through the V-belt drive. A gear train [...]

By |2017-07-24T11:54:25+05:30July 24, 2017|Shaper|Comments Off on Principal Parts of Shaper | Machine Tools | Industries | Engineering

Work of a Shaper | Machine Tools | Industries | Engineering

Shaper work is generally limited in size by the maximum length of stroke of the shaper ram. The shaper can machine a variety of plane surfaces, profiles, and contoured surfaces when equipped with a tracing attachment. Much of the work performed on shapers is done with the workpiece held in a shaper vise. The bottom of the shaper vise is [...]

By |2017-07-24T11:54:25+05:30July 24, 2017|Shaper|Comments Off on Work of a Shaper | Machine Tools | Industries | Engineering

Operations Performed on Shaper | Machine Tools | Industries | Engineering

The following points highlight the various operations performed on shaper in industries. The operations are: 1. Operations Involved in Shaping a Rectangular Job on Shaper 2. Machining a Thin Job on Shaper 3. Cutting an Angle on a Large Job 4. Cutting a Dovetail Bearing on a Shaper 5. Shaping a V or Key Way Centrally in a Block 6. [...]

By |2017-07-24T11:54:24+05:30July 24, 2017|Shaper|Comments Off on Operations Performed on Shaper | Machine Tools | Industries | Engineering
Go to Top